​Quality custom & restoration sheet metal work & repair

​A new mount plate will be attached

​Tooling holders are unboltable and are set up to use standard 13/16 shank planshing hammer tooling.

​It comes with a 1 hp vfd powered variable speed foot controled motor that runs on 220 power. As I get it more reassembled I will add pictures.

I used it a lot then was going to upgrade and never did.

Upper arms look like frog lags aka Kermit.

​As I sorta wind things down some I am selling my excess tools and equipment. I will keep this page updated as I add or sell stuff.

Price $3750 and I can supply some additional dies for more $$

phone calls always best way

206 234 8032 Danny.

​Phone calls always best way 206 234 8032 Danny Pascoe.

​Kirmet the power hammer.

​It will have a set of thumb nail shrink dies an upper flat die and a couple of lower radius dies ready to run.