​Quality custom & restoration sheet metal work & repair

​This is the Baileigh Industrial MH-19 Multi Power hammer  the ULTIMATE sheet metal forming machine, it works like a Yoder power hammer spring type & a Pullmax ridged recrocating machine simple pin change (90 seconds). It is fully adjustable in stroke & tooling height. It runs off of 220 single phase power & has a variable speed VFD with foot control, it has quick pin tooling change (45 seconds change time). It comes with a set of thumb nail shrinking dies 3 inch diameter, 1 flat upper die & 1 lower radius die.  The machine pictured is my personal & shop demo machine.

​The pricing will very depending on how you want it optioned with tooling, plus freight & any local sales tax for a new machine delivered to your address any where in the contential USA & must have a fork lift  to unload or the nearest freight dock for pick up lastly if  you are in the Pacific North West   (Seattle Washington area ) you can pick up at my shop & I can load it on your truck or trailer,  shipping weight 1600 LBS with the basic die set as stated at the top.  

I give 10 hrs free training at my shop with purchase a $650. value. ​I have been a Baileigh Industrial Distributor for 10 years so I sell & use the Baileigh tool line in my automotive restoration & custom sheet metal fab shop in Maple Valley Washington. Please feel free to call and set up an appointment to see & try out the ULTIMATE sheet metal forming machine or to discuss any of the  other fine Baileigh pieces of equipment .


                   ​shop phone             ​425 433 0294

                                                         ​​Danny Pascoe

​There is a wide variety of optional dies available in 3 inch, 2 1/2 and 2 inch diameters. There is also available 3/4 inch & 7/8 inch square shank adapters, plus 1/2 inch plate adapters so you can make you own tooling. The dies pictured below are some of the optional dies available.

​Baileigh MH-19 Multi Power  Hammer